Best price of RTV-2 Condensation Cure Silicone Rubber for sculpture molds

There are two methods to make molds, one is pouring way, the other is brushing way. Pls refer to the followings instructions

Step 1: prepare the original molds

Make sure your original molds perfect. fix it on a board. And fix the original mold on a board , then used four piece of board to enclose the original molds .

Step 2: Take 100 G parts A and add 2G parts B and mix them evenly.

Notes: Mold making silicon rubber is a kind of flowing liquid ,it contains two parts. Part A is a kind of flowing white liquid and part B is the curing agent or catalyst .Pls follow the step strictly:

1.Weigh the two part exactly by electronic weight..

If not , for example add two much catalyst , the operation time will be too fast to operate ,which will cause inconvenience to operate .

2.Mix part A and part B evenly.

Otherwise the silicon rubber will be partly solidified and this will give birth to difficulties in your final operation. What's more, the finished molds will meet a short life. All of these will cause a waste of silicon rubber.

Step 3: Vacuum pumping

Without exception, this step takes less than 10 minutes. Otherwise, it will cause cross linking reaction, and no more further steps will be available. 

Step 4: Pouring casting or Brush operation

Notes:1. For simple pattern products we suggest use pouring operation way , which will be very easy to operate and demould. Pourable silicone require light viscosity which will be easy to flow smoothly and easy to de-air .

2.For delicate pattern products we suggest use brushing operation way , which can copy the pattern exactly . Brushable silicone require high viscosity which won't be easy to flow away and easy to brush.

3.We suggest to set the silicone mold for another 12 hours after demould before put into large production.