Professional and creative team ! Looking forward to cooperate with you ~
prompt | Customers who need to change for the Anderson plug, will maintain the original output wire length, solder the wire from the clip, and then install Anderson! It is absolutely not allowed to arbitrarily modify the output line to be bold, lengthened, shortened, etc., causing a large current error or even damage. |
The goods are handmade, the appearance may be slightly scratched | IC GOGOGO store in our aliexpress store !~ |
information | Input voltage: AC 100v/110v --220v/250v Input power: the new version750W. Old version 675W Output voltage: DC constant voltage meets 2.6V-14.6V (suitable for 1S to 3S Li-ion Lipo and 1S to 4S Lifepo4) Output current: DC constant current is adjustable to 1-50A. (only constant current and constant voltage can be used as charger) Protection method: After the positive and negative poles are short-circuited, constant current output Appearance size: new version length 36CM* width 5.5CM* height 5.5CM. Cooling method: Air-cooled (built-in cooling fan, increasing speed with increasing temperature) Attached accessories: With two positive and negative wires and clips, (the power cord wire needs to be prepared by yourself) The output wire uses 80A high quality silicone wire. Lead-acid battery charging precautions: Lead-acid batteries do not support high-current charging, and should be charged with a current of 1/10 of the capacity. For example: a one-hundred lead-acid battery, you need to charge with 10 amps! The time must be 8-10 hours, the time is too fast, the current is too large, it will damage the battery. The lead-acid battery charging voltage is about 14.4 volts. The battery manufacturers are different. The voltage is slightly different. The instructions on the battery label shall prevail |
note | Connect the battery positive and negative can not be reversed (Red Positive + ; Black negative - ), the reverse will be bad |
input | AC 100V-250V. have over current protection ,short circuit protection . after protected , adjust current knot power off and re-start |
Instructions | The first step: the charger should not be connected to the battery, turn on the power, adjust the voltage knob to adjust the voltage, refer to the voltage display above the display screen, (4S lifepo4 battery 3.65v*4=14.6 volts, 3S li-ion lipo battery 4.2v *3=12.6V), adjust to the voltage you need. Step 2: Adjust the current to a minimum. After connecting the battery, adjust the current from small to large and adjust to the current you need. (In the charging process, it is not allowed to adjust the voltage knob again, otherwise overcharge or undercharge will occur) If the voltage is displayed, the voltage you set, the current becomes zero, and it is already full. |