ASTM A572 Gr50,S355JR U sheet piling hot rolled u shaped steel sheet pile

Steel Sheet Pile is a new type of environmentally friendly construction material, widely used in port, dike and retaining wall, bridge, dock, cofferdam engineering. steel sheet pile is a kind of non gravity, flexible plate support mode, maintenance and support by the wall wall (anchor) system group, with waterproof anti sand, silt prevention function. The stress characteristic and other supporting system, is mainly composed of a supporting wall to the retaining effect, by the support force and bearing wall buried part of passive earth pressure against the earth pressure in the active zone and the external load, so as to maintain the balance of the supporting system.

Application:

1. Used for the permanent constructional structure. Such as embankment, harbors, docks, retaining walls, anti-earthquake reinforcement project, and flood gates.

2. Used for the provisional structure to seal the mountain, provisionally to retain the wall, to cut off the river, to cofferdam, to lay the pipeline and to ward off the earth, the water or the sand.

3. Used for the flood-fighting and emergency rescues to prevent the flood, collapse, sink or sediment flow.

Steel sheet piles are long structural sections with a vertical interlocking system that creates a continuous wall. The walls are most often used to retain either soil or water. The ability of a sheet pile section to perform is dependent upon its geometry and the soils it is driven into. The pile transfers pressure from the high side of the wall to the soil in front of the wall.

There are permanent and temporary applications. Permanent sheet piles remain in the ground and serve as permanent retaining structures. Temporary sheet piles are designed to provide safe access for construction, and are then removed.

Hot rolled and cold formed are two primary methods of manufacturing sheet pile. While there are key differences between these two methods, the most important distinction is the interlock. Since hot rolled sheet piles are produced from steel at high temperatures, the interlock tends to be tighter than its cold formed counterpart. Normally, looser interlocks are not recommended in extremely hard driving conditions or for walls requiring low permeability. Hot rolled sheet piles are generally larger and have a broader range of strengths than cold form sheet piles, but there is a large overlap between the two, especially in the most common sizes.

ASTM A572 Gr50,S355JR U sheet piling hot rolled u shaped steel sheet pile

Email: sales2(@)tedaganghua.com

Skype: sophie09020

Wechat: 804220252

Office: +86 22 86896637 ext 610

Mob: +86 151 2230 7921

ASTM A572 Gr50,S355JR U sheet piling hot rolled u shaped steel sheet pile