9V to 60V 10A Brushless electrical bldc motor controller with RS485
ZM-6610M dc induction brushless motor driver features:
1. support voltage 9V~60V, rated output current 10A
2. support duty ratio speed regulation (pressure regulation), torque control (steady flow), speed closed-loop control (steady speed), position closed-loop control (Angle degree and distance control) a variety of speed control methods
3. support potential, analog signal, logic level, switching value, PWM, frequency, pulse, RS485, etc
Into the signal
4. supports analog signal voltage range configuration and logical level voltage configuration, and analog signal can support 0~ 3.3/5/10v, etc voltage range, logic level can support 0/3.3/5/12/24V, Support analog signal linearity adjustment and logic level threshold configuration.
5. supports RS485 multi-computer communication and modbus-rtu communication protocol, which is convenient for multiple controllers (such as PLC) communication control, support communication interrupt stop protection
6. supports acceleration and deceleration buffering time and acceleration control, which can automatically accelerate and decelerate within the specified stroke and accurately locate
7. motor current PID control, current control accuracy 0.1a, maximum start/load current, brake (brake) electricity flows can be configured separately;Support motor overload and stop-over current limit to prevent over - current damage motor
8. 6A continuous braking current is provided by the built-in high power brake resistance
9. supports motor phase sequence learning and hall error protection
10. supports positive and negative rotation limit of motor, which can be externally connected with two limit switches for positive rotation and reverse limit respectively
11. supports motor speed measurement, motor stop-over test/stop-over limit stop
12. supports fault alarm
13. 18kHz PWM frequency, motor speed control without PWM noise
14. small PWM dead zone, only 0.5us, PWM effective range 0.1%~100%
15. All interfaces are protected by ESD, which can adapt to complex site environment
16. use ARM cortex-m3 @72mhz processor
Application: research, production and field control
SIZE:
TECHNICAL PARAMETER:
item | parameter | remarks |
Power input voltage DC | DC 9V~60V | Do not connect the positive and negative power supply, or it may burn off |
maximum current output | 12A | Do not short circuit the motor output interface, otherwise it may burn drop the fuse. |
Rated output current | 10A | |
Maximum soft brake current | 6A | |
Hall sensor interface output voltage | 5V | |
Output voltage of completion/fault signal is | 3.3V | |
Motor rated current can be set range | 0.5-12A | Please configure the rated current parameters of the drive as and |
The range of load current | 0.5 A ~ 12 A, | |
Motor current detection accuracy | 0.2A | |
Current measurement resolution | 0.01 | |
Stability control accuracy | 0.02A | |
Single-end analog signal input voltage range | 0-10V | The voltage range can be configured, as well as configured |
Differential analog signal input voltage range | -3.3V ~ +3.3V | The voltage range can be configured, as well as configured |
The logical level voltage range | 0V ~ 24V | High and low level thresholds can be configured to support LvTTL, TTL, HvTTL, PLC, etc |
PWM/ pulse input interface supports voltage | 0V ~ 24V | When the configured logic level voltage does not exceed 5V, |
Writing: