M86-02 is a single board Microprocessor Trainer Kit based on 16 bit 8086 Microprocessor, which is widely used to train engineers to develop software/hardware for any industrial process & control. This Kit consists of power-full Monitor EPROM, RAM, I/O Lines, Timer/Counter, Serial, LCD Display and Keyboard for Man to Machine Interface.
Features
· 16K Bytes of EPROM with 16K bytes of Battery Backup RAM.
· 72 I/O Lines, Three Channel Timer/Counter, PC Serial Interface using USART, Interrupt Controller.
· 20x2 LCD Display with 101 ASCII Keyboard.
· Power-full Command like Single Stepping, Break Point, Full Clock Execution, Examine Memory/ Register.
· Uploading & Downloading to and from PC in Windows98/XP/NT.
· In-Built Power Supply.
Specifications
· 8086/8088 CPU operating at 2.5/5MHz
· 8086 Processor can be replaced by 8088 Processor
· On-board sockets provided to facilitate the use of 8087 Co-processor and 8089 I/O Processor
· 16K bytes of RAM using two nos. of 6264 with Battery Backup expandable up to 256KB.
· 16K bytes of powerful monitor EPROM using two nos. of 27512
· 72 I/O lines through 3 nos. of 8255 brought at 26 Pins FRC Connector to interface with IC-XX Series.
· 16 bit Timer/Counter through 8253 brought out at 20 Pins FRC Connector.
· RS-232C interface using 8251 brought out at 9 Pins D-Type Connector.
· On-board Interrupt controller using 8259 brought out at 20 Pins FRC Connector.
· On-board ADC using ADC-0809.
· On-board DAC using DAC-0800..
· On-board Temperature sensor using LM35.
· On-board 8 bit 8255 pot simulation using 8 way dip-switch & 8 leds.
· 20x2/40x2/20x4 Alphanumeric LCD Display with Backlite
· 101 ASCII Keyboard interface using 89c2051 operating @ 12MHz
· Powerful Commands like Examine/Edit Memory, Examine/Edit Register, Single stepping, Execution, Block Move can be used through ASCII Keyboard.
· On-board Single Line Assembler & Disassembler.
· Facility for Downloading/Uploading files from/to PC.
· All address, data & control lines are available on KXT Bus 50 pin FRC Connector to interface with SC-XX Series.
· All ICS are mounted on IC Sockets.
· Bare board Tested Glass Epoxy SMOBC PCB is used.
· In-Built Power Supply of +5V/2A, ±12V/250mA
· Attractive ABS Plastic enclosures.
· User's Manual with sample experiments