8016 RONGPENG Air Powered Economical Factory Price Air Nailers staplers
Model | 8016 |
Dimension | 48x145x211mm |
Weight | 0.85kg(1.8Lb) |
Required pressure | 70-110PSI(4.8-7.5br) |
Max.Pressure | 120PSI(8.3bar) |
Nail Capacity | 100pcs |
Description :
1) Innovative design with light weight.
2) Rear exhaust to protect work surfaces.
3) Steel top cap can be used as hammer at your needed working situation.
4) Soft grip handle with extra comfort and control.
5) Professional tool with hardened one piece piston.
6) Hard coated magazine increase durability.
Heat treated air inlet plug prolonged the life.
8) Easy loading latch for more comfortable loading. Standard equipment: stapler, carrying case, oil, allen wrenches and operating manual.
Air Nailer Trouble Shooting:
Symptom | Problem | Solutions |
Air nailer's leak near top of tool or in trigger area |
1.O-ring in trigger valve are damage 2. Air nailer's trigger valve head are damage 3.Air nailer's trigger valve stem, seal or O-ring are damaged |
1.Check and replace O-ring 2.Check and replace 3.Check and replace trigger valve stem, seal or O-ring |
Air Nailer's leak near bottom of tool |
1.Loose screws 2.Worn or damaged O-ring or bumper |
1.Tighten screws 2.Check and replace O-ring bumper |
Air leak between body and cylinder cap |
1.Loose screws 2.Worn or damaged O-ring or bumper |
1.Replace bumper 2.Adjust the air pressure |
Blade driving fastener too deep |
1.Worn bumper 2.Air nailer pressure is too high |
1.Verify adequate air supply 2.Place 2 or 6 drops of oil into inlet 3.Check and replace O-ring or seal 4.Replace damaged air nailer internl parts |
Air nailer does not operate well: can not drive fastener or operate slugishly |
1.Inadequate air supply 2.Inadequate lubrication 3.Worn or damaged air nailer's O-ring or seals 4.Exhaust port in cylinder head is blocked |
1.Verify adequate air supply 2.Place 2 or 6 drops of oil into air nailer's inlet 3.Check and replace O-ring or seal 4.Replace damaged internl parts |
Tool skips fasteners |
1.Worn bumper or damaged spring 2.Dirt in front plate of the air nailer 3.Dirt or damage prevent fasteners from moveing freely in spray gun's magazine 4.Worn or dry air nailer's O-ring on piston or lack of lubrication 5.Cylinder cover air nailer's seal leaking
|
1.Repalce bumper or pusher spring 2.Clean drive channel on front plate 3.Air nailer's magazine needs to be cleaned 4.O-ring need to be replaced and lubricate 5.Replace sealing washer |
Tool jams |
1.Incorrect or damaged fasteners 2.Damaged or worm driver guide 3.Air nailer's magazine or nose screw loose 4.Air nailer's magazine is dirty |
1.Change and use correct fastener 2.Check and replace the driver 3.Tighten the magazine 4.Clean the magazine |
Showroom