This model is Multifunctional digital Video/ Data/Ethernet Optical media converter, with 8 channel Video (for analog cameras) +1x 10/100Mbps Ethernet port (available for Ethernet networking, also available for IP cameras)+ RS485 data (reverse direction), specifications as below.
Video
Video: 8 channel
Video connector: BNC
Input / output impedance: 75 Ω (unbalanced)
Input / output voltage: typical 1Vpp (peak-to-peak), maximum 1.2Vpp
Bandwidth: 8MHz
Sampling: 15MHz high speed sampling
Digital Bit Width: 8/10/12 bits (bits)
Differential gain: (10% -90% APL) DG <1% (typical)
Differential phase: (10% -90% APL) DP <0.8 ° (typical)
Field tilt: <0.5%
Video signal to noise ratio (weighted): S / N ≥ 70dB (maximum optical link loss)
Data
Data: RS485, reverse direction.
Connector: Terminals block (2 wires)
Data rate DC-250Kbps
Data error rate is less than 10E-12
Maximum number of nodes 128
Maximum distance of 1200 meters.
It can support multiple data, compatible with all control keyboard, matrix protocol, hard disk video PTZ, alarm composite data, industrial application transmission.
Control equipment: PTZ decoder, control keyboard, matrix control data interface, high speed dome, industrial equipment
Ethernet
Interface rate: 10 /100Mbit/s adaptive, the default is 100Mbps working state
Interface type: UPC Cat5 cable RJ-45
Support Protocol: IEEE 802.3U 100Base-TX, 10 / 100M Ethernet standard
Work mode: full duplex or half duplex
Optical fiber
Optical Interface : FC/UPC
Wavelength : Single-mode 1310/1550μm (9/125μm)
Transmission distance : single-mode fiber:0-20KM
Power input
AC100~240V, DC12V