1.Products Detail Information:
735A(S) Floor install sanitary ware self-cleaning automatic siphonic toilet closet
Size:800*420*600mm
Color:White
S-trap:300/400mm roughing-in
Grade:A
Water Flush: 6L/4L
2.Technical Parameters
3.Rating technique index
Specification:AC 220V,960W,50HZ
Cleaning fitting
Water amount:
Hip cleaning-water amount adjustment 0.4-1.0L/min(water pressure 0.19Mpa<2.0kgf/cm h>)
Female-water amount adjustment 0.5-1.0L/min( water pressure 0.19Mpa<2.0kgf/cm h>)
Water temperature:Temperature adjustment-from normal temperature to 40 °c
Heater capacity:900W
Warm water capacity:1.0L
Cleaning method:Add shift flex cleaning function
Safe fitting:Temperature fuse,prevent from temperature too high,avoid empty fire drift on-off
Prevent reflux:Reflux-prevention piece
Drying fitting
Warm wind temperature:From normal temperature to 55 °c
Wind speed:0.3m/min
Heater capacity:240W
Safe fitting:Temperature fuse
Keep-warm seat
Seat temperature:Temperature adjustable scope:from normal temperature to 40 °c
Heater capacity:30W
Safe fitting:Prevent from temperature too high
Eliminative olid fitting
Manner:Eliminative olid touch medium
Wind speed:0.09m/min
Water supply pressure:Lowest water pressure is 0.1Mpa(1kgf/cm),highest water pressure is
0.5Mpa(5kgf/cm)
Water supply temperature:10-35 °c
Surrounding using temperature scope:10-40 °c
Remote contorl batteries:DC 1.5V Model NO.:size 7,2 pcs
4.Using instrcution
Deodorizing automatically
Sit on the intelligent toilet seat,it begins to deodorize automatically,after standing up for 20 seconds,
it stops working.
•Attention:Deodorization device had an immediate effect on the inner pan but for the outer parts.
Damp fitting
Intelligent seat circle and cover is deviced for preventing from falling down repidly as damping and buffer.
•Remark:Open-close seat cover quickly is forbidden or else the damp fitting cover,seat circle are damaged.
Manual adjustable pressure valve
If water pressure is too much when cleaning,please adjust pressure valve clockwise to appropriate pressure,
the effect will be better if you adjust it with remote control also.
Air pump supercharged
Press "AIR PUMP" button on remote control to supercharge water if the water pressure is not strong enough
while cleaning.(apply to model H)
•Remark:if water is not enough in tank,light is shining continuously,please confirm if any water pressure or not,
wait until is comes,please fill the tank with full of water according to the initial installation instruction,it will work
in good condition.
Power saving
Power saving light shows the intelligent toilet in the state of saving electricity for 6 hours,continue on 24 hours
circulate,memorize power saving condition.
Electrical source
Press the key of power,the itelligent toilet is turned on;Press it again,it is switched off.
Light
Press the light key,the shimmer on the intelligent toilet is lighted;press it again,the light is turned off.
Nozzle cleaning
Press the nozzle cleaning key,the intelligent toilet washes the spout.Press is again hip cleaning washes the
spout;Press it once more,the spout back,washes itself.
5.Attention in using
♦ If you don't sit on the toilet,it will not squirt water,hip cleaning,female cleaning,drying button fail to work.
Remark:Don't lean your back to seatcover after sitting on the toilet,or else to damage the seatcover.
♦ Water is oozed out for cleaning the nozzle while the nozzle is flexing.
♦ Cleaning nozzle for more than 2 minutes,self-stop spraying to continue using,you could press the switch
again.
♦ Toilet keeps spraying for one or two seconds if you stand up in cleaning please be sure to press stop key
before standing up.
♦ Press drying key,due to toilet is draining the dirty things firstly,you need to wait about 10 seconds before
wind comes out.
♦ Press hip or female cleaning key,due to self-clean nozzle and need to vent cold water.It takes about 10
seconds before nozzle sprays water.Please be patient and wait.
smart toilet Smart toilet & Intelligent toilet 751D Floor Mounted Installation Type automatic smart sensor toilet bidet design