4x4 truck tipper 5t dump truck with crane for mining

 4x4 truck tipper 5t dump truck with crane for mining

Mine transport vehicle precautions
1. It is forbidden for anyone to lift the upper and lower excavators and deliver articles during the operation. It is not allowed to maintain while working; do not adjust the engine and hydraulic system and electric control system at will; pay attention to selecting and creating a reasonable working surface.

2. When the material is unloaded, it should be stopped after the vehicle is stopped; when the material is not hitting any part of the dump truck, the height of the bucket should be lowered; the bucket is crossed from the top of the dump truck.

3. It is forbidden to use a bucket to crush a solid object; if it encounters a large stone or a hard object, it should be removed first and then continue to work; it is forbidden to excavate the rock of level 5 or above.

4. In the process of agricultural operation and operation, it is necessary to check whether the temperature of the hydraulic oil is normal.

5, four is not like the car in the operation of the wire, crossroads, bridges and culverts, understand the situation and then pass, if necessary, set a special person command; the distance between the excavator and the high-voltage wire should not be less than 5m; should avoid walking backwards as much as possible.

Product parameters

details

The following is a brief description of the precautions for the use and maintenance of mining four-wheelers in winter:
1. When the temperature is lower than 5 °C, the start of the engine is more difficult. At this time, the engine needs to be started with some auxiliary mechanical skills. For example, the engine can be heated or steam preheated before starting, and the temperature reaches 30 °C- Restart at 40 °C or above (the diesel engine is generally compression-ignition type, it is necessary to preheat the cylinder temperature and heat the temperature of the misty diesel).
2. The engine start recommendation should not exceed 15 seconds at a time. If it cannot be started, the start switch should be released. After stopping for 1 minute, start again. After starting, you need to idle for a period of time before starting to drive. Note that the idle time should not be exceeded. Long (3-5 minutes), too long, it is easy to form carbon deposits on the inner wall of the cylinder, and there is a phenomenon of pulling the cylinder. One idling can charge the battery, and the other will bring the water temperature to 55 °C and the brake pressure to 0.4 MPa or more.
3. When the water temperature of the diesel engine is higher than 55 °C and the oil temperature is higher than 45 °C, the whole machine can enter the full load operation state. When the mining four-wheeled vehicle works normally, the water temperature and oil temperature of the engine should not exceed 95 °C. The oil temperature of the tank should not exceed 110 °C.
4. When the temperature is lower than 0 °C, the mining four-wheeled vehicle will stop the cooling water in the water tank, engine, oil cooler and torque converter oil cooler to avoid freezing the body; the air reservoir should be drained frequently. To prevent icing, resulting in brake failure.
5. If the mining four-wheeled vehicle has not been used for more than half a month, the engine must be started once every 15 days and run for a period of time to charge the battery; if the shutdown time exceeds one month, please remove the battery and charge it with a charger. It is necessary to properly move the mining four-wheeled vehicle to change the pressure-receiving part of the tire to prevent the tire from being deformed; if the vehicle needs to be parked for more than two months, the battery negative pole must be disconnected or removed.
6. The fuel used in winter diesel engines should be -10# light diesel oil. In cold regions, the fuel should be -35# light diesel oil, and the engine oil of diesel engine should be CF grade.
7. When the temperature is below 0 °C, the antifreeze concentration should be checked regularly, and untreated water is prohibited as the engine coolant.

24Hours after-sales service by email or phone.

2. 100% Response rate.

3. Warranty: 12 months warranty , During the warranty period, if the machine is not damaged by human, we will provide the damaged parts for free.Provide video teaching and online service support, and provide third-party intervention maintenance if necessary

4.Beyond the warranty period, all spare parts offered to you with our cost price .

5. Our customer-oriented sales and technical team are always at your service

1 Q: How about your packing?

A: According your requirement, half assemled or assembled. One machine in one wooden box.We can also pack according to your requirements.

Q: 2.How to purchase the products which you want?

A: Choose one product which you are interested and leave message

Or Inform us your request for brand and model number

Q: 3.How to confirm the quality before place the order?

A:If you are in China, warmly welcome you visit our factory, check the Quality, meanwhile welcome to visit our office for reference.

Q: 4.How about the after-sale services?

A: If any problems after receiving the bulk goods, please do not hesitate to contact us for dealing, our engineer will service at any time to make you satisfied.