Advantages
Surface Drying Time | 8-15 minutes |
Hard Drying Time | 30-60 minutes |
Spray Rate | ≥ 98% (no waste) |
Spray Speed | ≥ 1.5g/s |
Fineness |
≥ 15um (no block)
|
Adhesiveness |
≥ 2 Grade (no peeling)
|
Bending | 2 mm (good flexbility) |
Hardness | HB (scratch resistant) |
Area to cover | About 2 square meters/ can |
Color Chart
PREPARATION
For best results, clean surface of grease, wax, rust and dust. Scuff or lightly sand all glossy surfaces removing any unwanted bumps or flaking paint, then dust off. Prime raw timber or metal with Aeropak primer and allow to fully dry.
IMPORTANT : Shake the can vigorously for one minute before use. Holding the can 30cm from prepared surface, begin by applying one light mist coat, spraying in a continuous motion across the surface working left to right. Pause, allowing the mist coat to set for 30 to 60 seconds, then apply additional coats working at 90° to the first coat. If a thicker finish is required, allow at least one hour between extra coats. When painting over existing paint always check compatibility.
Clean any over spray with mineral turps or general-purpose thinners. For better long term storage, turn can upside down and spray until no paint is coming out.
Spray unneeded product on to newspaper dispose to waste.
Empty can is recyclable.
1.Do not use near fire or naked flame.
2.Do not puncture or incinerate even if empty.
3.Keep in a cool place out of direct sunlight.
4.Do not store above 50°C. / 122 F
5.Never spray at eyes or face.
SAFETY WARNINGS
Keep out of reach of children
If swallowed seek medical advice immediately.
Warning - intentional misuse by deliberately inhaling contents
can be harmful or even fatal.
OUR COMPANY
OUR EXHIBITIONS
OUR SERVICES
1.Customization
Offer OEM and ODM
I-like offers OEM and ODM service for free with its first-class design team, professional technical advisers, a management team, and high-quality research and development staffs. We bring together the elite group of modern marketing to provide comprehensive?solutions so that help enlarge customers’ business and get good reputation.
2.Service
Pre-sale service:
Any of the items be of interest to you, we will pleased to give you details.
On-purchase service:
We provide OEM and ODM. We will help you to design your own design style and deal with the problems you meet timely before the products reach your hand.
After-service:
If any of our customers find the product is defective(but we will try our best to avoid this problem), we will help you to solve the problems first. If it was our fault, we will undertake our responsibility and have a refund.
3.Our competitive edge over other suppliers is that we offer solutions rather than supplying goods and services. We provide an excellent combination between prices, quality & responsibility.