4000w 5000w 6000w split phase 110v/220v pure sine power inverter
Product Features:
• High overload ability
• Low battery voltage trip selectable, extracting max power from various batteries with different protections.
• Low quiescent current, selectable sensing cycle to reduce power consumption. On battery charger • 3-step intelligent battery charging.
• 8 preset battery type selector plus de-sulphation for totallly flat batteries.
• Powerful charge rate up to 70Amp, selectable charging current.
• PFC(Power Factor Correction) for charger, less power consumption than conventional units. On Transfer • Delay before transfer, extra protections for loads under generator mode.
• Input AC voltage range selectable, for different kinds of loads.
• 8 ms typical transfer time, guarantees power continuity.
• 30A/40A through current ablility.
• Output voltage regulation optional. On remote control & other featuers • Ability to switch the unit on/off.
• Ability to select/deselect power saver mode.
• 17 alarms/warnings, informative for easier operation and trouble-shooting.
• LCD status display available.
• RS232 communication port optional.
Product Specification
Model NO. | PSW7 1000 | PSW7 2000 | PSW7 3000 | PSW7 4000 | PSW7 5000 | PSW7 6000 | |
Nominal Power | 1000w | 2000w | 3000w | 4000w | 5000w | 6000w | |
AC Input | Phase & waveform | single phase & pure sinewave | |||||
voltage | 100V/120V/220V/230V/240VAC | ||||||
Acceptable Voltage | 194-243VAC\164-243VAC(wide mode) | ||||||
Line Low Transfer | 85V±4%/184(154 wide mode±4%) | ||||||
Line Low Return | 95V±4%/194(164 wide mode±4%) | ||||||
Line High Transfer | 135±4%/253±4% | ||||||
Line High Return | 127±4%/243±4% | ||||||
Frequency | 50Hz or 60Hz(Auto Sensing) | ||||||
Line Low Transfer | 47Hz for 50Hz, 57Hz for 60Hz | ||||||
Line High Transfer | 55Hz for 50Hz, 65Hz for 60Hz | ||||||
AC Output | Phase & waveform | Single phase & pure sinewave(bypass mode sync to input) | |||||
voltage | 100V/120V/220V/230V/240VAC(sane as input on bypass mode) | ||||||
Voltage Regulation | ±10%rms(bypass mode sync to input) | ||||||
Frequency | 50Hz or 60Hz(Auto Sensing) | ||||||
Crest Power | 3 times of ratings | ||||||
Short Circuit Protection | Yes, shutdown after 10 minutes | ||||||
Power Factor | 0.9~1 | ||||||
DC Input | Battery Voltage | 12/24V | 12/24/48V | 12/24/48V | 24/48V | 24/48V | 24/48V |
Minimum Start Voltage | 10V for 12V, 20V for 24V, 40V for 48V | ||||||
Low Battery Alarm | 10.5V for 12V, 21V for 24V, 42V for 48V | ||||||
Low Battery Transfer | 10V for 12V, 20V for 24V, 40V for 48V | ||||||
High Voltage Alarm | 16V for 12V, 32V for 24V, 62.8V for 48V | ||||||
Max Charging Current | 20A-75A | ||||||
Over Charge Voltage | 15.7V for 12V, 31.4V for 24V, 62.8V for 48V | ||||||
Transfer Efficiency | Line Mode | >95% | |||||
Battery Mode | >85% | ||||||
Power Saver | Available when the load is less than 50 Watts | ||||||
Indicators | 7-LED Display | From the right to the left, LED1 line mode(green lighting),LED2 inverter mode(green lighting),LED3 charging mode(yellow lighting),LED4 Fully Charged(green lighting),LED5 over heat shutdown(red lighting),LED6 Overloaded shutdown(red lighting),LED7 Saving Mode(green lighting) | |||||
3-LED Display | Charging Mode(green lighting),inverter mode(green lighting),Alarm(red lighting) | ||||||
LCD Display | Input Voltage,Output Voltage,Frequency,Battery Voltage,Load | ||||||
Switch selector | Saving Mode is on/off when push the switch forwards/backwards, keeping it horisontal is turning the inverter off | ||||||
Audible Alarm | Sounding when the heatsink's tem is over 105ºC and shutdown after 30 seconds | ||||||
Protections | low battery,over charging,over temp,over load | ||||||
Communications | RJ11/RS232(Optional) | ||||||
Environmental | Operating Environment | 0-40ºC,0-90%RH(non-condensing) | |||||
Audible Noise | <60dB | ||||||
Physical | |||||||
Net Weight(KG) | 14 | 19 | 23 | 35 | 44 | 44 | |
Dimension (mm) | 218*179*442 | 218*179*598 |