1. This rod holder clamps on so it's easy to rail mount without drilling hole in the boat, clamp fits any rail
25mm(1inch) OD to 32mm(1-1/4inch) OD;
2. Adjusts 360 degrees and locks at any angle, simple to remove when not in use;
3. 9inch Length 51mm OD tube with 6mm 316 stainless steel pin inside,the pin across the bottom that keeps the rod from rotating;
4. 316 stainless steel for use in all marine environments. Rubber tipped end protects rods and soft black flange gasket protects boat rail;
5. Polished by hand to a mirror finish to assist in making a quality part. In the passivation process after buffing, acid and rinsing remove surface contaminants from the products and produce a hydrous oxide film which enhances corrosion resistance. Every production shipment tested and certified.
25mm(1inch) OD to 32mm(1-1/4inch) OD;
2. Adjusts 360 degrees and locks at any angle, simple to remove when not in use;
3. 9inch Length 51mm OD tube with 6mm 316 stainless steel pin inside,the pin across the bottom that keeps the rod from rotating;
4. 316 stainless steel for use in all marine environments. Rubber tipped end protects rods and soft black flange gasket protects boat rail;
5. Polished by hand to a mirror finish to assist in making a quality part. In the passivation process after buffing, acid and rinsing remove surface contaminants from the products and produce a hydrous oxide film which enhances corrosion resistance. Every production shipment tested and certified.