24v 4.5kw 60v 4kw washing machine ceiling fan brushless dc motor stator and rotor for treadmill
| Motor type | Output Power | Voltage | Load | Speed | Rated Torque | Efficiency | Noise | IP Class |
| KW | V | A | RPM | Nm | % | dB | ||
| VOL-BL300A12 | 0.3 | 12 | 27.17 | 1500 | 1.91 | 92 | 62 | IP 54 |
| VOL-BL300A24 | 0.3 | 24 | 13.59 | 1500 | 1.91 | 92 | 62 | IP 54 |
| VOL-BL300A48 | 0.3 | 48 | 6.79 | 1500 | 1.91 | 92 | 62 | IP 54 |
| VOL-BL300A72 | 0.3 | 72 | 4.53 | 1500 | 1.91 | 92 | 62 | IP 54 |
| VOL-BL300A110 | 0.3 | 110 ac | 1.71 | 1500 | 1.91 | 92 | 62 | IP 54 |
| VOL-BL300A220 | 0.3 | 220 ac | 0.86 | 1500 | 1.91 | 92 | 62 | IP 54 |
Q:Motor has been running then fails to start,what to do?
A:Likely cause: Fuse or circuit breaker is tripped.
What to do: Replace the fuse or reset the breaker.
Likely cause: Armature is shorted. Motor may make a humming noise and the circuit breaker or fuse will trip.
What to do: Disassemble motor and inspect the armature for a burnt coil. Inspect the commutator for burnt bars. If this condition exists, the motor needs to be replaced.
Likely cause: The brushes may be worn down too far and no longer make contact with the commutator.
What to do: Check the brushes to make sure that they are still making contact with the commutator. Contact manufacturer for brushes.
Likely cause: Controller may be defective.
What to do: Verify voltage is coming out of the controller.
Q: On initial installation, motor fails to start up,what to do?
A: Likely cause: Motor is incorrectly wired
What to do: Verify that the motor is wired correctly.
Likely cause: No output power from controller.
What to do: Measure voltage coming from the controller.
Likely cause: Motor is damaged and the armature is rubbing against the magnets.
What to do: Disassemble motor and see if the armature can be realigned by reassembly. Motor may have to be replaced.
Q: Motor takes too long to accelerate,what to do?
A: Likely cause: Motor controller not properly set.
What to do: Adjust the acceleration trim pot of the controller.
Likely cause: Brushes are worn.
What to do: Verify brush length.
Likely cause: Bearings may be defective.
What to do: Inspect bearings. Noisy or rough bearings should be replaced.
Q: Motor runs in the wrong direction,what to do?
A: Likely cause: Incorrect wiring
What to do: Interchange the two motor leads.
Q: Motor runs OK but has a clicking noise,what to do?
A: Likely cause: Suspect a burr on the commutator.
What to do: Remove burr from commutator using a commutator stone.
- Step 1Find your interested products by search keywords
- Step 2Contact the supplier by clicking ”Enquire” or “request meeting” button, otherwise, you also could consult our import consultant.
- Step 3After verifying your email, get response from suppliers or our trade manager will contact you as soon as possible
- Step 4Set up meeting with the Chinese supplier without language barrier