2022 Christmas Gift Kids Led Night Light Moon Lamp 16 Color 8cm 10cm 15cm 20cm 22cm Customised Big Floating 3D Galaxy Moon Lamp

Name:3D printing touch moon light Materials:PLA plastic Specifications:please refer to thr diameter of the product Brightness: Stepless Adjustment Color temperature: 3000K / 6000K Battery capacity:300-500MHA Charging time: 6 - 8 hours Working time: 3-8hours ( depends on brightness ) Charging mode:USB DC5V Charging current:1A Using environmrnt:0-40<75% Features: 1. 3D printing technology: print layer by layer, restore the real appearance of the moon 2. Charging port and switch integration: simple, beautiful and practical, easy to operate 3. Warm and gentle LED lights: touch the metal ring to switch the color and turn off the light 4. You can hold it on your hand. Easy to put anywhere you like with the wood holder 5. Safe and environmentally friendly: PLA material extracted from corn stalks, hard and smooth, non-toxic, odorless,environmentally friendly 6. Long using time: 300mAh built-in battery, after the full charge, the lamp can be used 8 - 30 hours, a full charge takes about 6- 8 hours 7. A perfect gift: express your love with this warm gift. Your kids or beloved one are unable to resist this charming gift. And it's also a great decoration for your house 8. 6 diameters of the moon light to choose: 8cm, 10cm, 12cm, 15cm, 18cm Note: If you need other 8-10cm sizes or 16 colors, please contact us for quotation How To Use? 1. Touch the metal ring at the bottom of the moon lamp to turn on / off the light and change color. Three colors tap :You can pat the moon lamp to switch the color of the lights 2. Long press the metal ring to adjust the brightness. 3. Insert the DC connector into the metal ring at the bottom of the moon lamp to charge, the red light is always on during the charging.The red light will automatically turn off when fully charged. 4.16colors with 24keys remote can control the moon lamp . 5.If your hand is too dry or the temperature is too low, the light may not respond. 6.If the light is not on, you can try charging for 1-2 hours first. Or wonder if the brightness of the light is adjusted to the darkest. Notice: 1.When charging,the ball becomes red,full,and then extinguished; 2.Because the installation of the circuit required,the sphere edge will have seam(as shown). 3.3D priting forming principle causes the object surface to have the contour line phenomenon. 4.This product does not have waterproof ability,not strong acid,alkali. 5.This product can not be strongly hit or fall from high places.