1600W computer PS-2 ATX power supply / psu JLNE-1600G

1600W computer PS-2 ATX  power supply / psu JLNE-1600G

Input:  
1.1 Input Voltage Range: 200~240Vac.
1.2 Normal Voltage Range: 220/230Vac.
1.3 Input Frequency Range: 50-60 Hz.
1.4 Max Input AC current: 10A MAX. @ 230Vac.
1.5 Inrush Current: No hazards shall occur or components damage.
1.6 Efficiency: ≥87%@230Vac 60Hz, load follow “2.2 DC output current table” Load 5.
1.7 Active PFC

Output :  

 1      Static Output Characteristics:

Max. Output Power: 1650W

1. Noise Test: Noise Bandwidth is From 10Hz To 20 MHz.

2. Add 0.1uf Ceramic Capacitor /10uf Tantalum Capacitor At Output Connector Terminals For Ripple & Noise Measurements.

3. Maximum Continuous DC Output Power shall not exceed 1650W.

4.+3.3V and +5V total O/P power cannot exceed 100W.

      The +12Vcombine is not exceed the 130A

5. Main O/P Shall Be Enabled By Pulled "Remote" Pin To TTL Low Level, And Disabled By Pulled "Remote" Pin To TTL High Level.

Protections:

1 Over Voltage Protection: +5V:  7.0V Maximum.

+12V:  16.5V Maximum

 +3.3V:  4.3V Maximum

2 Short Circuit Protection: The power supply shall shut down and latch off for shorting. +5V, +12V, -12V or +3.3v rails to com and each output rail and shorting +5vsb P/S can latch down or automatically Recovery When the fault condition is removed.

4 No Load operation: No damage or hazardous condition will occur.

5 OCP: +12V without,+3.3V&+5V with

6 With Fan Speed Control Function:

Environment:

1      Operating Temperature: 0℃ TO 40℃

2   Operating Relative Humidity: 5% TO 95%.

3   Storage Temperature: -40 TO + 70 ℃.

4   Storage Relative Humidity: 5% TO 95%.

5   Altitude: Operate Properly At Any Altitude Between 0 To 10,000 Feet. Storage: 50,000 Feet.

6   Non-operating shock: Half sine shock

        Duration 11ms by 50G acceleratio

       Minimum 3 shocks on each of six faces.

7 Non-Operating Random Vibration: