14S 48V | Detail | Spec | ||||
Discharge | Maximal Continuous Discharging Current | 15A | 25A | 35A | 45A | 60A |
Peak Discharging Current | 65±10A | 65±10A | 100±20A | 165±30A | 200±30A | |
Over Current Protection Current | 65±10A | 65±10A | 100±20A | 165±30A | 200±30A | |
Charge | Charging Voltage | 59.5V | ||||
Charging Current | 10A | 10A | 20A | 30A | 50A | |
If separate port charging current is 8A | ||||||
Over charge protection | Over Charge Detection Voltage | 4.25±0.025V | ||||
Over Charge Detection Delay Time | 1S | |||||
Over Charger Release Voltage | 4.15±0.05V | |||||
Cell balancing | Cell balancing Detection Voltage | 4.18V | ||||
Cell balancing Release Voltage | 4.18V | |||||
Cell balancing Current | 30±5mA | |||||
Over discharge protection | Over Discharge Detection Voltage | 2.7±0.1V | ||||
Over Discharge Detection Delay Time | 1S | |||||
Over Discharger Release Voltage | 3.0±0.1V | |||||
Over current protection | Over Current Detection Voltage | 150mV | ||||
Over Current Detection Delay Time | 1MS | |||||
Over Current Protection Condition | Disconnect the load | |||||
Short Protection | Detection Condition | Exterior Short Curcuit | ||||
Detection Delay Time | 250uS | |||||
Release Condition | Disconnect the load | |||||
Temperature Protection | 65℃ or 75℃ | For optional | ||||
Internal Resistance | MOSFET | ≤20mΩ | ≤20mΩ | ≤10mΩ | ≤10mΩ | ≤10mΩ |
Size | 15A(62*50*9mm) 25A(62*50*12mm) 35A 45A(80*61*12mm) 60A(80*61*16mm) |
1. Overview
INR-1448100 PCB is used for 14 series 48V battery pack.
We can design it for various lithium batteries like LiFepo4, LiMn2O4, and Li-polymer etc.
The main functions are: over charge protection, over discharge protection, over current protection, short-circuit protection, temperature protection etc.
According to the customer request we can develop PCM in different sizes and structures.
BMS manufactured by high quality Mos and IC imported . Keep your battery long cycle serivce life time.
2. Advantage
Use top quality (A-level) protective integrated circuit IC, from the solution of Japan.
Strong load ability, constant discharge current 200A, use high voltage resistance, low inner
resistance power Mosfet. The heat sink will greatly help cooling.
IC itself has power balancing function. The circuit is simple and reliable.
Typical voltage detection for each cell. So each battery will be prevented over charged or over discharged. Over current and short circuit protection
function is very reliable.Long time short circuit of the load won’t affect the PCB and the battery.Temperature protection during charging and discharging.
Extreme low power consumption. The consumption of the whole device is less than 50uA.
PCB use high anti-corrosion, high water resistance, high impedance ESD conformal Coating