Anti-fungus silicone sealant high performance silicone sealant with OEM service
DESCRIPTION
Anti-fungus silicone sealant high performance silicone sealant with OEM service is acetoxy cure, one part RTV silicone sealant. Faster cure than normal silicone sealant. Can be applied on glass, ceramics vitreous enamels, shelves, counter cabinets, signs and many other building materials.
FEATURES
GNS G33 ANTI-FUNGUS SILICONE SEALANT
l Easy to use – one part, no mixing required. Can be dispensed with an ordinary caulking gun.
l Cures to a strong, flexible seal capable of withstanding movement in and around the joint.
l Acetic Cure; Fast Cure.
l Can be applied in any season.
l Excellent resistance to weathering, UV light, vibration, moisture, ozone, temperature extremes, airborne pollutants, cleaning detergents and many solvents.
l Non-slumping; can be used in vertical and overhead joints.
PACKAGING
GNS G33 ANTI-FUNGUS SILICONE SEALANT
Standard Size:
280ml recyclable plastic cartridge, 24ctgs/ctn
Special Size:
Contact us for special size.
COLORS
GNS G33 ANTI-FUNGUS SILICONE SEALANT
is available four standard colors: translucent, white, black, aluminum.
Contact us for special colours.
PERFORMANCE DATA
Test Parameter |
Unit |
Result |
As Supplied Tested at 23℃ and 50% RH |
||
Specific Gravity |
g/ml |
0.98±0.02 |
Flow (sag or slump) |
mm |
0 |
Extrusion Rate Skin Time |
ml/minute minute |
150 5~10 |
Tack-free Time |
hour |
≤1.0 |
Curing time (5mm) |
hour |
≤12 |
As Cured-after 21 days at 23℃ and 50% RH |
||
Durometer Hardness, Shore A |
Points |
22 |
Movement Capability |
% |
±25 |
Tensile/Modulus at 50% Elongation |
Mpa |
0.24 |
Tensile/Modulus at 100% Elongation |
Mpa |
0.28 |
Ultimate Tensile Strength Ultimate Elongation at Break |
Mpa % |
0.32 250 |
Specification Writers: Please contact your local Authorized Distributor or our Technical Services Department before writing
specifications on this product. These values are not intended for use in preparing specifications
APPLICATION
Cut seal on top of cartridge. Screw on nozzle and cut the nozzle at 45°angle to the desired shape and size. For better appearance, cover outside of joint areas with masking tape before application. Tool immediately after sealant application and remove masking tape before sealant skins.
LIMITATIONS
l Do not use for structural glazing.
l Not recommended for use on materials where the cure by-product (acetic acid vapor) may cause corrosion, discoloration or where the sealant may affect their appearance (e.g. galvanized iron, copper, brass, zinc-coated steel, concrete, cement, brick, limestone, marble and similar highly porous stone finishes).
l Do not use when substrate temperature is above 50℃ or surfaces that are wet, oily, greasy, dusty or dirty.
l Do not use for sub-graded application, confined space or surfaces that require post finishes or paintings.
l Do not clean or treat the sealant with materials, solvents or cleaning agents that may affect or discolor the sealant, particularly during sealant cure.
l Not for permanent or continuous water immersion.
l Not intended for food-contact applications.
l Not recommended for use on polycarbonate plastic sheeting. Suitability for use on other types of plastic should be tested prior to application.