Manual of Solenoid Valves
A.Air/Oils/Liquid Type Series
1.Series' Function :This valve is solenoid valve type of automatic control actuators , it can automatic control or remote control the pipelines' opening or closing of the medium of air/water/gas etc, this valves are of widely application/large scope of characters of working voltages ,long working like etc.
2.Structures: a)Pilot type ,open or close the valves with the pressure difference (controlled by coil on-off the signal), reliable working ,quickly action,stable performance . Applicable pressure : 0.03Mpa-1.0Mpa, TEM. ≤90℃.
Installation
You should read the manual before installation to check if it meats your requirements.
You should clean the pipe line before using , impurity medium pipeline should install strainer to forbid the impurity affect the valves working
You should install the solenoid valve according the direction of the valve , fluid direction same as the arrow tip.
Solenoid valve normally should be horizon installed ,some product can be installed in any angle , but if it is permissible, you should install the valve with the coil upper horizontally.
When in icy surrounding , when reacted the solenoid valve ,you should warm up the valve body , or take heat preservation measure for the valves.
You should check the connection or connectors' tightening after connection of the solenoid valve's power line or power line connector , loosing will cause the valve failure to working
When the solenoid valve should working or operate continually ,you should install the bypass pipeline for maintain and no need to stop the production
When the solenoid is not working for long time , you should clean the impurity ,disassemble the parts and clean and recover it then you can use the solenoid valve