General information
Standard drive pins with 0.145” shank Diameter
INTRODUCTION
Drive pins with a 0.300" diameter head are designed for permanently fastening a fixture to concrete, some types of masonry andA36 orA572 structural steel. Drive pins are manufactured with a 0.145"diameter shank in various lengths. Knurled shank designs are available to increase performance in steel base materials.A plastic flute is mounted over the point to retain the drive pin in the fastener guide of the tool providing guidance during the driving operation.
PJ25 |
25mm |
1" |
PJ32 |
32mm |
1-1/4" |
PJ37 |
37mm |
1-1/2" |
PJ42 |
42mm |
1-5/8" |
PJ52 |
52mm |
2" |
PJ57 |
57mm |
2-1/4" |
PJ62 |
62mm |
2-1/2" |
PJ75 |
75mm |
3" |
Note:1-Accessory:with 8mm dia.flute 2-Knurled shank available |
Drive pin is driven by gun powder combustion, and can be driven into the hard base of concrete, steel, brick masonry, stone and so on, PD nail material is #45 carbon steel, length range is from 13mm-76mmHardness should be 50HRC-57HRC, shank should be bent to 60° without breaking, if shank length is less than 30mm, no need to check bending angle.
Port : Shanghai ,Ningbo,Tianjin